iFlight Beast F7 AIO V2

The iFlight Blitz is a mini 20x20 flight controller with an improved circuit design, better components, and lower electrical noise. The flight controller has many plug-and-play ports including DJI HD VTX Connector, GPS, Crossfire, and more. The flight controller has LED indicators for visual debugging. Paired with a 55A Blitz ESC makes this a power stack in a small package.

Specifications:

• MCU: STM32 F722
• Gyro: BMI270
• Barometer: DPS310
• OSD Chip: AT7456
• Flash: 16MB (Blackbox flash)
• UARTS: 6
• Motor outputs: 4x (SH1.0 connector)
• I2C serial: SDA / SLA pads
• Smart Audio / IRC Tramp VTX protocol supported
• LED controller: Yes
• Beeper pad: Yes
• Firmware target: IFRC-IFLIGHT_BLITZ_F722
• Mount pattern: 20x20 mm / 4mm PCB hole diameter, silicon
• grommets for M3 screws
• Dimensions: 30.5x27 mm
• Weight: 5g

 Wiring suggestion:

• UART 1 for VTX HD / Analog
• UART 2 for a Receiver
• UART 3/4/5 for GPS or other sensors that require a serial port
• UART 6 for ESC Telemetry

Tips

1. F722 MCU has an inner inverter.
2. SBUS、CRSF、ELRS、IBUS、DSM ETC... can be connected to any unused UART_RX we suggest you connect to Uart_RX2
3. Frsky SmartPort, Tramp & Smart audio can be connected to any unused UART_TX， we suggest you connect to Uart_TX1
4. F.port can be connected to any unused UART_TX， we suggest you connect to Uart_TX2

Included Connectors (Plug-and-Play wire harness):

• 1x SH1.0 - 9pin connector for HD VTX/Analog VTX&CAM （5V/BAT/G/VO/T1/R1/5V/G/VI）
• 1x SH1.0 - 8pin connector for ESC（R6/CUR/M4/M3/M2/M1/BAT/G)
• 1x SH1.0 - 6pin connector for any Receiver or DJI（3V3/R2i/5V/G/R2/T2）
• 1x SH1.0 - 4Pin connector GPS (T4/R4/G/5V)
• 1x SH1.0 - 4Pin connector LED & Beeper (BUZ/LED/G/5V)

What's in the package?

• 1 x BLITZ Mini F7 V1.1 Flight Controller
• 1 set of FC connectors (as above)
• 1 set of silicone grommets